Ali-rs232-upgrade-tool-v1-2-0 Downloader Full | Reliable • 2024 |

| Method | Action | |--------|--------| | | Turn on the device from rear switch or plug into mains. | | Standby trigger | Press Standby on remote or front panel. | | Button combo | Hold “CH+” + “Power” or “OK” + “Menu” while powering on. | | Factory menu | Some boxes have a hidden menu: Menu → 0000 → Software Upgrade → RS232. |

Click or “Start” – the tool will display: Waiting for download request from target... 5. Trigger the Download on the Device Depending on your receiver, do one of the following after the tool is waiting: ali-rs232-upgrade-tool-v1-2-0 downloader Full

Would you like help identifying your device’s trigger method or firmware matching rules? | Method | Action | |--------|--------| | |

| Setting | Value | |---------|-------| | | Select the correct COM number (e.g., COM1, COM3 – check Windows Device Manager) | | Baud Rate | 115200 (most ALi chipsets) – try 38400 or 57600 if that fails | | Firmware File | Click “Load” / “Open” → choose your .upd / .bin file | | Upgrade Mode | Usually “Normal” or “All Code” (do not select Bootloader unless specified) | | | Factory menu | Some boxes have

| Method | Action | |--------|--------| | | Turn on the device from rear switch or plug into mains. | | Standby trigger | Press Standby on remote or front panel. | | Button combo | Hold “CH+” + “Power” or “OK” + “Menu” while powering on. | | Factory menu | Some boxes have a hidden menu: Menu → 0000 → Software Upgrade → RS232. |

Click or “Start” – the tool will display: Waiting for download request from target... 5. Trigger the Download on the Device Depending on your receiver, do one of the following after the tool is waiting:

Would you like help identifying your device’s trigger method or firmware matching rules?

| Setting | Value | |---------|-------| | | Select the correct COM number (e.g., COM1, COM3 – check Windows Device Manager) | | Baud Rate | 115200 (most ALi chipsets) – try 38400 or 57600 if that fails | | Firmware File | Click “Load” / “Open” → choose your .upd / .bin file | | Upgrade Mode | Usually “Normal” or “All Code” (do not select Bootloader unless specified) |