Copy to SD/USB → insert → reset → bootloader verifies → flashes automatically. At MMI_BL# :
# Concatenate parts if you have separate files cat bl2.bin bl32.bin u-boot.bin kernel.itb rootfs.squashfs > mmi_update.bin openssl dgst -sha256 -sign private_key.pem -out signature.bin mmi_update.bin cat mmi_update.bin signature.bin > mmi_update_signed.bin bootloader version 2.40 mmi -h43 download-
Flash via UART or USB. | Symptom | Likely fix | |---------|-------------| | Bootloader won't enter download mode | Check force recovery pin, power cycle, try another SD card (≤32 GB) | | XMODEM transfer fails | Lower baud rate to 115200, disable flow control, use TeraTerm or Minicom | | Signature verification failed | Firmware not signed for this unit – use official update | | Flash erase timeout | Bad NAND block – run nand scrub if available | | Bootloop after flash | Try erasing user data partition and factory reset | 7. Hardware Access Points (example for H43) | Signal | PCB pad / resistor | |--------|--------------------| | UART TX | R124 (near MCU) | | UART RX | R125 | | GND | Any shield / large copper | | FORCE_RECOVERY | R34 pad – connect to 3.3V | | BOOT_MODE | TP10 – pull high | Copy to SD/USB → insert → reset →
# Build U-Boot for H43 make rcar_h3_ulcb_defconfig make CROSS_COMPILE=aarch64-linux-gnu- mkimage -A arm64 -T firmware -C none -O linux -a 0x48080000 -e 0x48080000 -d my_kernel.bin uImage Hardware Access Points (example for H43) | Signal
MMI_BL# erase 0x40000000 0x2000000 MMI_BL# download (Start XMODEM-1K transfer from terminal: firmware.bin) MMI_BL# flash 0x40000000 0x123456 MMI_BL# verify MMI_BL# boot Addresses (example for H43):